World Dryer Corporation | Electric Aire Series

	Electric Aire Hand Dryers \| Specifications

Electric Aire Model LE – Cast Aluminum Cover Surface Mount	Features and Benefits
	Materials
	Mechanisms
	Warranty
	Electrical Characteristics
	Dimensions
	Mounting Diagram
	Planning Guide

ELECTRIC AIRE MODEL LE

Materials

Cover construction of cast aluminum .125" (3.17mm) thick
Powder coated baked enamel in an appliance white finish
Two tamper-resistant screws lock cover securely in place
Corrosion resistant materials
Rubber noise isolation mounting

Mechanisms

Motor is induction (brushless) 1/8 HP, 2850 rpm (50 Hz), 3360 rpm (60 Hz), thermal protected
3900 LFM
NiCr wire coil element with fiber glass core and auto re-set thermostat
Active infrared sensor with vandal circuit shut off function

Warranty

3 year limited parts warranty

ELECTRIC AIRE MODEL LE
Electrical Characteristics
Model	Volts	Hz	AMPs	Watts
LE 1	115	60	13.0	1500
LE 4	230	60	6.5	1500
LE 48	230	*50	6.5	1500
*50Hz units available for Export Markets only.

ELECTRIC AIRE MODEL LE
Dimensions	Surface Mount
Outer Dimensions	11.2" W x 8.82" H x 5.91" D 284.5mm x 224mm x 150mm
Weight	9.5 Lbs.
Recommended Mounting Height (Distance from floor to bottom of dryer)
Men	46" (1168 mm)
Women	44" (1118 mm)
Children, ages 3-7	32" (812 mm)
Children, ages 8-10	36" (914 mm)
Children, ages 11-13	40" (1016 mm)
Children, ages 14-17	44" (1118 mm)
Disabled mounting height	40" (1016 mm)
Model LE dryers should not be placed less than 18" above projections which may interfere with the operation of the automatic sensor.

MODEL LE MOUNTING DIAGRAM

*Refer to recommended mounting height table

HAND DRYER PLANNING GUIDE

Quantity Estimate
Average traffic washroom - 1 dryer per 2 washbasins
Heavy traffic washroom - 1 dryer per washbasin
54" Bradley sink - 4 dryers per sink

Dryer Placement
Hand dryers should be placed at least 2 feet apart, near but not over the washbasin. In congested areas dryer should be placed to create a traffic flow from washbasin to dryer to exit.

Dryer Installation
Hand dryers require a dedicated circuit and must be properly grounded.
GFI Circuit protection is recommended.
One side of dryer should be mounted to stud.

Model LE Surface Mount/Automatic Only Specification Guide
Cover of high impact cast aluminum. Motor shall be a induction type operating at 2850 RPM at rated load. Dryer shall deliver 3900 LFM. Dryer shall be activated by means of an infrared emitting/receiving electronic control device, automatically detecting hands when present. Hand dryer shall be listed under re-examination service of Underwriter's Laboratories, Inc. and certified by the Canadian Standards Association.



		About Us \| Sanitation \| What's New \| Contact Us \| Site Index © 2000-2005 World Dryer Corporation. All rights reserved. Hamilton & Bond

Electric Aire Hand Dryers | Specifications