2922-2873 COVER: die-cast aluminum finished with white epoxy paint with Steritouch®. Cover fixed to the base plate with tamper proof screws.
ADJUSTABLE MOTOR: motor is a thermally-protected universal type operating at 23,400 RPM. Adjustable motor control switch has three settings; HI, MED and LOW.
HEATING ELEMENT: 400 watt heating element constructed of nichrome wire and protected by an automatic resetting thermal cutoff. Heater can be turned ON or OFF via internal switch.
SENSOR OPERATION: Automatic infrared sensor with a 3 second run-on time and a 30 second vandal shut-off.
BASE PLATE: Aluminum with four mounting holes and a .88" knockout.
Installation: Verify all rough-in dimensions prior to installation. Hand dryers require a dedicated 15 amp circuit and must be properly grounded. GFI Circuit protection is recommended. One side of dryer should be mounted to a stud. For proper mounting heights, see installation manual.
Operation: Place hands 3"–6" below nozzle to activate air flow. Dryer will stop after hands are removed from air flow.
FREE SHIPPING via FedEx Ground to anywhere in the Contiguous United States.