2923-2874 COVER: 1/16" (2 mm) thick one-piece stainless steel; satin finish.
Cover fixed to the base plate with vandal-proof lock screws and lock with special key wrench.
MOTOR: High pressure universal brush (31,000 RPM). Motor shall have replaceable brushes for extending service life.
HEATING ELEMENT: Dryer will incorporate a nichrome wire heating element protected by an automatic resetting thermal cutoff.
ADJUSTABLE SENSOR OPERATION: Dryer shall be activated by an automatic infrared sensor with a 30 second vandal shut-off. Control board shall contain a HI/LOW speed control switch. Dryer shall provide an exit air temperature of 130°F at an ambient temperature of 70°F. BASE PLATE: The Wall Mounting plate shall be constructed of die-cast aluminum finished with chrome plating.
Installation: Verify all rough-in dimensions prior to installation. Hand dryers require a dedicated circuit with a minimum of 15 amps and must be properly grounded. GFI Circuit protection is recommended. One side of dryer should be mounted to a stud.
Operation: Place hands 3"–6" below nozzle to activate air flow. Dryer will stop two seconds after hands are removed from air flow.
FREE SHIPPING via FedEx Ground to anywhere in the Contiguous United States