Replacement CIRCUIT BOARD MODULE and SENSOR ASSEMBLY for the ASI 0197-2 HAND DRYER (208V-240V/Older Models*) - Part# 10-A0142-0129

ASI CIRCUIT BOARD MODULE (CBM) and SENSOR ASSEMBLY (Part# 10-A0142-0129) for previous generation of Model 10-0197-2 TURBO-Dri (208V-240V), Automatic, High-Speed, Surface-Mounted Hand Dryer (discontinued part / only limited stock available)

*PLEASE NOTE: This Circuit Board Module and Sensor Assembly (Part# 10-A0142-0129) applies only to the previous generation of model 0197-2 with the single-port nozzle AND with the higher-voltage motor (regardless of cover material).  Please see the image below.

*** If your TURBO-Dri has instead the multi-port nozzle (see picture below) and is high-voltage (208V-240V), you have the current version of 10-0197-2.  Please see the separate listing for CBM and Sensor Assembly (Part# 10-A0437-0129).

*** Finally, if your TURBO-Dri is low voltage (110V/120V), please see the separate listing for CBM and Sensor Assembly (Part# A0141-0129) regardless of nozzle configuration or cover material. 

Both the CBM and IR Sensor in this assembly are rated for 208V-240V, 50/60Hz.

Please note that neither the 208V-240V Control Board (Part# 10-A0142) nor the Automatic Sensor (Part# 10-A0129) are sold separately, but both are included with this Assembly (Part#10-A0142-0129). 

You could buy an entirely new unit to replace your AMERICAN SPECIALTIES 0197-2 hand dryer (part of the TURBO-Dri Series) in any of three different cover choices.  But with the correct replacement parts, you can keep your hand dryer in working condition at a fraction of the cost of replacing the entire unit.

HAND DRYER SHOWN FOR IDENTIFICATION PURPOSES ONLY

To purchase a complete replacement hand dryer for this model, please see the ASI 0197 listings.